OBP Pro-Drift V2 12"-15" Locking Hydraulic Aluminum Handbrake
Handbrake turns are common in rallying and Solo II (parking lot autocross) events. Success depends on quickly locking and then releasing the rear brakes, but a stock cable-operated system will not act quickly enough to allow full control. Hydraulic handbrakes work much faster, and with more precision than cable systems. This is why hydraulic handbrakes are found on all professional rally cars. They can also be used to help hold a car at the starting line of a road race, hillclimb, or drag race.
This unit features a short billet aluminum handle with a lightweight steel base and a locking mechanism. The lock can be used to hold the car briefly while checking in at the end of a stage. The lock swings up and clips out of the way to prevent accidental locking during competition. The sculpted grip is adjustable for length from 12 5/8" to 15" (320mm - 380mm). You can assemble it with the handle horizontal or vertical to suit your vehicle and driving style. Includes lever, base, and clevis to connect the lever to your master cylinder. Master cylinder, plumbing, and mounting hardware are not included.
To install, bolt the base to the transmission tunnel so the handle is near the steering wheel (you may need to reinforce the tunnel to reduce flexing). Connect the rear brake line from the footbrake master cylinder outlet to the master cylinder inlet. Connect the line from the handbrake master outlet to the rear brakes. When the handbrake is off, the brakes will function normally.
Note: Not for use as a parking brake! Hydraulic handbrakes are for competition use only. They do not maintain pressure for more than a few minutes, which will eventually let the car roll away. They are intended for use only in short bursts (less than one minute per brake application).